5.1 電芯使用環境 Cell usage conditions
充電溫度 Charge temperature :-40~55℃
放電溫度 Discharge temperature :-40~55℃
5.2 電芯試驗環境 Cell testing conditions
除非有特殊說明,所有測試必須在25±2℃下完成。
Unless otherwise specified,all tests stated should be done at 25±2℃.5.3 測量?jī)x表要求 Requirement of the testing equipment
電壓測量裝置 :不低于0.5級
The voltage measurement device:not less than 0.5 grade
電流測試裝置:不低于0.5級
The current measurement device:Not less 0.5 grade
交流阻抗測量頻率:1000 Hz
AC Impedance 1000 Hz
溫度儀表要求:精度為≤0.5℃
Temperature meter:Precision ≤ 0.5℃
時間測試公差:±0.1%
Time measurement tolerance:±0.1%
尺寸測量公差:±0.1%
The size measurement tolerance;±0.1%
質量測量公差:±0.1%
The quality measurement tolerance 0.1%
5.4 電化學性能 Electrochemical Characteristics
除非有特殊說明,否則所有樣品均為新鮮電芯,且按標準充電和標準放電方式進行測試。
Unless otherwise specified,the cell should be fresh cell and tested by standard
charge and standard discharge.
No.
序號
Item
測試項目
Test method and
conditions
測試方法與條件
Criterion
性能標準
5.4.1
倍 率 放 電 性 能
Rate discharge
capability
按標準充電方式充電后,在25±
2℃下以給定放電倍率N C恒流
放電至2.5V。Standard charge
followed by constant current
(N C) discharge to 2.5V at
specified discharge rates at
容量保持率 =
N C放電容量
1C 放電容量
× 100%
≥ 80%
Capacity Retension
=
discharge capacity at N C
discharge capacity at 1C
≥ 80%25±2℃.
5.4.2
快 充 循 環 壽 命
Quick charge
cycle life
在25±2℃條件下,按照“2.1和
2.2”方法測完初始性能后,產
品以5C將其充電至4.2V,以3C
恒流放電至2.5V并靜置5min,
循環測試1000周后。上述測試
過程為一個周期,測試過程需重
復上述6次上述周期,最終實現
6000次壽命測試。Under 25±
2℃, test the cell’s original
performance by“2.1 and 2.2
methods”, and then charge
it to 4.2V by 5C current,
discharge it to 2.5V at 3C
constant current, after this
rest 5min, cycle this
processes 1000. Regarded
the testing process at one
cycle, and repeated it 6
times, until it reached 6000
times.
容量保持率 =
第6000次循環的放電容量
初始放電容量
≥ 80%
Capacity Retension
=
discharge capacity of 6000th cycel
original discharge capacity
≥ 80%
5.4.3 低溫性能測試Low 按標準充電方式充電后,在指定 -20℃:容量保持率≥80%temperature
performance
溫度下以1C(2500mA)恒流放
電 截 至 到 2.5V 。 Standard
charge , and discharge to
2.5V at 1C(2500mA) current
under specified temperature.
-30℃:容量保持率≥75%
-40℃: 容量保持率≥70%
-20℃:Capacity retention≥80%
-30℃:Capacity retention≥75%
-40℃:Capacity retention≥70%
上一篇我們送上的文章是
NEC鋰電池:磷酸鐵鋰電池適合海船的5大理由 , _!在下一篇繼續做詳細介紹,如需了解更多,請持續關注。
本文由
日本NEC鋰電池中國營銷中心于2023-11-19 17:09:46 整理發布。
轉載請注明出處.